A roof leak under solar panels is usually caused by a failed seal at a mounting point, a conduit penetration, or an ordinary roof problem that the panels happen to be hiding. The fix is to find the true source first, protect the inside of the house, and then have a solar contractor and a roofer work together, because most leak repairs under an array mean lifting panels off the roof before anyone can reach the shingles.
This guide walks Florida Panhandle homeowners through how to tell where the water is coming from, what to do in the first day, who to call, and how to keep it from happening again.
Is the leak really coming from the solar mounts?
Not always. A new ceiling stain under the part of the roof that holds panels makes the solar system the obvious suspect, but water rarely drips straight down. It can enter at one spot, run along the roof deck, a rafter or the top of a ceiling joist, and show up several feet away. Plumbing vents, valleys, skylights, chimneys, attic fans and worn shingles leak on homes with and without solar.
A few clues help narrow it down:
- Timing. A leak that started within the first year or two after installation, or right after other roof work, points toward the mounts or the wiring penetration.
- Weather. Leaks that only appear in wind-driven rain often come from flashing and edges. Leaks after every steady rain point toward a failed seal or a damaged shingle.
- Location in the attic. With a flashlight during or right after rain, look for wet wood, rusty nail tips or dark stains on the underside of the deck. A wet ring around a lag bolt or the spot where the solar conduit enters the attic is a strong sign.
Where leaks around solar panels usually start
Most residential rooftop systems are held on with mounts bolted through the roof into the rafters, each one sealed and flashed. When one of these leaks, the cause is usually one of the following:
- Flashing or sealant that failed. Years of Florida sun and heat can dry out sealant, and a mount installed without proper flashing depends entirely on that sealant.
- A bolt that missed the rafter. A lag driven only into the decking can loosen in high winds and open a path for water.
- The wiring penetration. Conduit that passes through the roof needs its own flashing or roof jack. A poorly sealed one is a common leak point.
- Cracked or lifted shingles. Foot traffic during installation or later service can crack brittle shingles near the array.
- Debris dams. Pine needles and leaves collect under and behind panels, hold water against the roof and slow drainage.
- Storm damage. High winds can loosen racking, lift shingles at the edge of the array, or drive debris into the roof.
What to do in the first 24 hours
The first goal is to limit damage inside the house and keep everyone safe.
- Catch the water. Put buckets or towels down and move furniture and electronics out of the way. If a ceiling is sagging with water, keep people out of the room.
- Watch for water near electrical parts. If water is near a light fixture, outlet, your main electrical panel, the inverter or solar wiring, turn off that circuit and shut the solar system down using the shutdown steps on the labels at your equipment. Do not touch wet electrical equipment.
- Document everything. Take dated photos of the stain, any dripping, the attic and the outside of the roof from the ground.
- Note the weather. Write down when it rained and how hard. This helps whoever diagnoses the leak.
- Call for help. Start with a solar contractor who can inspect the mounts and, if needed, remove panels so the roof can be reached.
Why you should not climb up and seal it yourself
A tube of roofing sealant looks like a quick fix, but it usually makes things worse. Smearing sealant on top of a mount can trap water underneath, hide the real source, and complicate any workmanship or roof warranty claim. Walking between panels can also crack shingles and damage panel glass or wiring.
Rooftop solar arrays carry electrical current whenever the sun is up, even when the system is switched off at the inverter. Repairs at the mounts often mean disconnecting and lifting modules, which is work for a licensed solar contractor.
Roofer, solar contractor, or both?
Many roofers will not work around or under solar panels, and many solar companies do not do roofing. In practice, most leak repairs under an array go like this:
- A solar contractor inspects the mounts, flashing and wiring penetration.
- If the problem is at a mount, the contractor can often lift the nearby panels, remove the mount, repair or replace the flashing, and reinstall it into the rafter.
- If the roof itself is the problem, the affected panels are removed so a roofer can repair the area, and then the panels are reinstalled and tested.
- If the roof is near the end of its life, it usually makes sense to plan a full removal and reinstall around a re-roof rather than patch it twice.
If the company that installed your system has closed, you are not stuck. MSM Solar services systems of any brand and age, including orphaned systems whose installer is no longer in business. Learn more about our solar service calls in the Florida Panhandle.
How the repair usually works
A typical leak repair follows a predictable order. The contractor shuts the system down, removes the panels over the suspect area, and inspects the mounts, flashing and decking. Damaged or wet decking may need replacement before the roof surface is repaired. Mounts are then reattached into rafters with proper flashing, wiring is checked, panels go back on, and the system is restarted and tested to confirm it is producing normally.
Service-call pricing at MSM Solar is quoted up front, so you know the cost of the visit before work starts, and larger repairs are quoted in writing.
Leaks after a hurricane or tropical storm
After a storm, a new leak under panels may be part of wider roof damage. Get the house safe and dry first, then call your insurance company to ask how they want the claim handled; policies differ, so ask before work starts and keep every photo and invoice. A post-storm inspection of the array helps separate solar damage from roof damage, which matters when more than one contractor is involved.
Homeowners from Navarre to Panama City see this every hurricane season: wind-driven rain finds weak spots that a normal summer shower never reaches.
Solar Cost Calculator – Florida Panhandle Only
* Estimate based on $3.25 per watt for solar installation.
* For Tesla Powerwall 3 Batteries, $15,000 for the first battery, $12,000 for each additional battery.
* Other variations and types of Batteries are available.
Preventing leaks on a solar roof
- Start with a sound roof. Before going solar, have the roof's age and condition checked. Installing on a roof that needs replacing soon guarantees a removal and reinstall later.
- Ask how mounts are sealed. A good installer can explain the flashing method used for your roof type and confirm that mounts go into rafters.
- Keep debris clear. Trim overhanging branches and have needles and leaves removed from under the array when they build up.
- Look in the attic after big storms. A quick flashlight check near the mounts and the conduit entry catches small problems early.
- Keep records. Save your installation documents, permit, panel layout and warranty papers so a future technician can find every penetration.
Frequently asked questions
Do solar panels make a roof more likely to leak?
A properly installed system with flashed mounts set into rafters should not cause leaks. Most leaks trace back to installation shortcuts, aging sealant, storm damage or roof problems unrelated to the panels.
Can a roofer fix a leak under my solar panels?
Usually only after a solar contractor removes the panels over the area. Most roofers will not lift or rewire solar modules.
Should I turn off my solar system if the roof is leaking?
If water is anywhere near electrical equipment, wiring or the inverter, shut the system down using the labeled shutdown steps and stay clear of wet equipment. Otherwise, let the technician decide during the visit.
My installer went out of business. Who can repair the mounts?
MSM Solar works on any brand and age of system, including orphaned systems. A real person calls back within 2 business days.
Conclusion
MSM Solar works with homeowners in Havana, Holt, Laurel Hill and Lynn Haven, and in every town between Pensacola and Apalachicola.
A roof leak under solar panels is fixable, but the order matters: protect the house, document the damage, find the true source, and have the panels lifted before anyone patches the roof. Skip the sealant tube and call a licensed solar contractor who can work with your roofer. MSM Solar is based in Crestview at 5662 Old Bethel Rd, holds Florida Certified Solar Contractor License CVC57236, and serves homes across the Panhandle, including Crestview and Pensacola. Call (850) 737-5197 to schedule an inspection.